Guide d'installation Rapide du Système de Haut-parleurs Directionnels SonicBeam

 

 

Nos SonicBeams sont rapides et faciles à installer vous-même.

 

Avant de commencer, assurez-vous que vous disposez des éléments suivants:

  • Myriad II Amp
  • Source de courant
  • Haut-parleur
  • Câbles: USB Vable, câble audio, 3 (2 pour SB-47) Câble de haut-parleur de conducteur
  • 3 Conducteur Mic Fil
 

1)Branchez le micro et le fil du haut-parleur à l'amplificateur et au haut-parleur. Si le système ne dispose pas de la fonction SmartVolume, aucune connexion de micro n'est requise.

Modeles SB-24 et SB-40

Modeles SB-18 et SB-47

SB-47.jpg
 

2) Connect audio cable to the amplifier and speaker. USB connection is for software setting adjustments, sensors and SmartVolume. There are no audio over USB capabilities. 

 
 
 

3) Connect the power supply to the amplifier. Plug the power supply into an outlet. 

 
 

4) Push the power button on the front of the amplifier. 

 
 

5) Play the program on the player and check the speaker for sound. 

 

Troubleshooting Tips

No audio but LED is on: 

  1. Be sure power button is pressed in
  2. Be sure mic and speaker wires are not swapped
  3. Plug audio cable into alternate known source

Unable to adjust volume: Pot is intentionally off (set in software)

LED is off: Check outlet power

LED flashes: Check outlet power and power switch is in (USB power only) 

LED flashes green and red: 

  1. Green indicates presence of audio
  2. Red indicates the presence of some power
  3. LED may show red and green with only USB power but without speaker power